Safety Technical Operating Regulations for Die Forgers
作者:admin 来源:本站 发布时间:2019-03-29 02:39:42 浏览量:
Strictly abide by the general forger safety skills operating procedures. When loading and unloading the positioning pin of the die, the upper die should be well supported. When installing the device, it should be noted that no one should stand near the hammer in order to prevent the positioning pin or the hammer head from falling off and injuring people. The touch plane of swallow tail of forging die should be kept clean, and no debris should be allowed to avoid the gap between the touch plane of forging die and the two horizontal planes of machine base.
The upper die should be supported well before being loaded, and it should not be slammed or oscillated. The pin and wedge iron of the fixed upper die should be close to the direction of the operator, and the hammer head and swallow tail should not be exposed at 100mm, so as to avoid injuring people during forging.
When the hammer head is not stopped in operation, it is forbidden to extend the hand into the forging die or to take forgings during the stroke of the hammer head. When checking equipment or forgings, parking should be done first, the valve should be closed, the gasket should be selected to support the hammer head, and the starting handle should be locked.
When forging large workpiece, iron hoop should be grasped tightly. When multi-person lifting operation, it is necessary to cooperate with each other and obey the unified command.
During the operation, the pin of the fixed die should be checked at any time for loosening and loosening. Discover looseness, stop work, repair. If steam or air leaks are found, work should be stopped and timely maintenance should be carried out.